09.12.2012 Views

Server Alarms - Avaya Support

Server Alarms - Avaya Support

Server Alarms - Avaya Support

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Table 569: VC DSP Port Local TDM Loopback Test (#1104) 2 of 3<br />

Error<br />

Code<br />

VC DSP Port Local TDM Loopback Test (#1104)<br />

1002 ABORT The system could not allocate time slots for the test. The system may be<br />

under heavy traffic conditions, or it may have time slots out-of-service due<br />

to TDM-BUS errors. A system is considered under heavy traffic when the<br />

Call Processing Occupancy is greater than 50% or when the System<br />

Management and the Call Processing Occupancies together exceed<br />

65%.<br />

1. Enter status health to view the occupancy measurements.<br />

2. Enter display errors and resolve any TDM-BUS (TDM Bus)<br />

errors.<br />

3. If the system has no TDM-BUS errors and is not handling heavy<br />

traffic, retry the command at 1-minute intervals up to 5 times.<br />

1003 ABORT The system could not allocate a tone receiver for the test. The system<br />

may be oversized for the number of Tone Detectors present, or some<br />

Tone Detectors may be out of service.<br />

1. Enter list measurements tone-receiver to see information<br />

regarding the system’s tone receivers.<br />

2. Resolve any TTR-LEV (TTR Level) errors.<br />

3. Resolve any TONE-PT (Tone Generator) errors.<br />

4. Retry the command at 1-minute intervals up to 5 times.<br />

1004 ABORT The port is seized by a user for a valid call. Enter status station for<br />

the station associated with this port and determine whether the port is<br />

available for testing.<br />

1. Retry the command at 1-minute intervals up to 5 times.<br />

2000 ABORT Response to the test was not received within the allowed time.<br />

1. If this result occurs repeatedly, attempt to reset the port with<br />

busyout port location, reset port location, and<br />

release port location.<br />

2. Rerun the test. If this result occurs again, replace the circuit pack.<br />

2012<br />

2100<br />

2103<br />

Test<br />

Result<br />

Description / Recommendation<br />

ABORT Internal system error.<br />

Could not allocate the necessary resources to run this test.<br />

The system could not make the conference connection for the test<br />

1. Retry the command at 1-minute intervals up to 5 times.<br />

2 of 3<br />

Communication Manager Release 5.0 Issue 4 January 2008 1911

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!