Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 187: DS1-BD Error Log Entries 4 of 4
Error Type Aux
Data
2817 Minor Alarm
Inquiry test (#143)
3073 to
3160 (s)
3329 to
3345 (t)
Any Slip Alarm Inquiry
test (#144)
Any Misframe Alarm
Inquiry test (#145)
3840 (u) Any None
3900 (v) Any CPE Loopback
Jack test (#1212)
3901(w) Any Far CSU
Loopback test
(#1213)
3902 (x) Any One-Way Span
test (#1214)
3999 (y) Any
Associated Test Alarm
Level
MIN
WRN†
MIN
WRN†
MIN
WRN†
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to the test’s description and follow the recommended procedures.
b. Error Type 1: the circuit pack stopped functioning or is not completely administered. The
alarm is logged approximately 15 minutes after the circuit pack has been removed or 11
minutes after the SAKI test (#53) fails.
To be completely administered, a DS1 circuit pack must:
● Have an entry in the circuit plan field in change circuit-packs
● Be administered using add ds1 location
On/Off
Board
Recommended Action
OFF test board location
OFF test board location r 6
OFF test board location r 6
● Be physically inserted in the correct slot
If the circuit pack has an entry in the circuit plan and either of the other two conditions are
not met, a MINOR alarm is logged. To resolve the error, either:
● Make sure all conditions for administration are met and that a functioning DS1 circuit
pack is inserted in the correct slot, or
● Completely remove the DS1-BD from the system:
1. Remove any administered DS1 trunks or access endpoints associated with the circuit
pack from their trunk groups.
722 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
4 of 4