Server Alarms - Avaya Support

Table 508: BRI Port Local LAN Looparound Test (#618) 2 of 2
Error
Code
BRI Port Local TDM Looparound Test (#619)
This test is destructive.
BRI Port Local TDM Looparound Test (#619)
1144 ABORT The Processor Port Network Packet Bus is out-of-service.
1. Follow the repair procedures for the PKT-BUS (Packet Bus).
2. After completing Step 1, enter test port long location, and
view the results of the BRI Port Local LAN Looparound Test #618 to
verify the repair.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
1144 ABRT The PPN’s packet bus is out-of-service.
1. Follow the repair procedures for the packet bus.
2. Issue test port long location and review the results of the
BRI Port Local LAN Looparound test to verify the repair.
2012
2100
Test
Result
Description / Recommendation
ABORT Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The looparound test has failed.
1. If the test fails repeatedly, attempt to reset the circuit pack if the other
ports on the board are idle.
2. Rerun the test. If the test fails again, enter test pkt pn#. If this
fails, follow the failure procedures in PKT-BUS (Packet Bus).
3. If the tests executed in step 2 pass, the problem is local to the BRI
board. Replace the circuit pack.
PASS The BRI Port Local LAN Looparound test has passed.
1. Enter release board location to put the board and ports back
into service.
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1751