Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 576: Digital Terminal Remote Looparound Test (#1201) 2 of 3
Error
Code
Test
Result
Description / Recommendation
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Enter display errors and resolve any TTR-LEV (TTR Level)
errors.
3. Enter display errors and resolve any TONE-PT (Tone
Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display port location to determine the station extension
or attendant number of the port.
2. Enter status station or status attendant to determine the
service state of the port. If the port is in use, wait until it is idle before
resetting. Attendants are always in use (off-hook) if the handset is
plugged in and the port is not busied out.
3. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT The installed circuit pack does not support this operation. Ignore this error.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
1015 ABORT The station is not busied out.
1. Enter busyout station and repeat the test.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT System resources required to run this test are not available.
1. Make sure the terminal is connected and repeat the test.
2. If the test fails, replace the terminal and repeat the test.
3. Retry the command at 1-minute intervals up to 5 times.
1924 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 3