Server Alarms - Avaya Support

CLSFY-PT (Call Classifier Port)
CLSFY-PT (Call Classifier Port)
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
CLSFY-PT MAJ
MIN
WRN
The TN744 Call Classifier is a service circuit pack that provides specialized tone detection
capabilities to support the Outbound Call Management (OCM) and Inbound Call Management
(ICM) features. The TN744 supports both A-law and Mu-law companding.
The TN744 has eight ports (CLSFY-PTs), each capable of supporting call classification,
touch-tone reception and MFC-tone generation and detection. The CLSFY-PT MO implements
a set of tests designed to ensure proper operation of the Call Classifier.
Error log entries and recommended actions
Table 169: CLSFY-PT Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm Level On/Off
Board
test port location Call Classifier Port
Recommended Action
1 any Tone Detector Audit/
Update Test (#43)
MAJ / MIN (a) ON test port location r 2
18 busyout port WRN OFF release port location
257 (b) 17666 Tone Detector Audit/
Update Test (#43)
513 (c) any Tone Detection
Verification Test
(#42)
MAJ / MIN (a) ON test port location r 3
MAJ / MIN (a) ON test port location r 3
Notes:
a. A major alarm is raised if the total number of call classifier ports currently in-service is less
than or equal to 1/2 of the administered threshold number. For major or minor alarm, run the
short test sequence on the alarmed port and follow the error code procedures for the
individual tests.
The in-service threshold number for alarming call classifier ports is administered using the
change system-parameters maintenance.
1. Enter these commands in order: busyout board, reset board, release board.
The board reset is required to reload on-board RAM associated with the TN744’s DSPs.
This takes all 8 Tone Detector ports out of service for a few seconds. Only 4 of the 8
Communication Manager Release 5.0 Issue 4 January 2008 649