Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 617: DSP Port TDM Looparound Test (#1380) 2 of 2
Error
Code
Test
Result
ANY FAIL The test did not detect the test tone through the looparound connection.
1. Test the tone-clock in the port network that contains the media
processor under test.
2. If the tone-clock is healthy, test the media processor board again.
3. If the test continues to fail, replace the media processor board.
PASS The board is functioning properly.
0 NO
BOARD
Description / Recommendation
See NO BOARD for repair procedures.
Windows 2000 Reset Test (#1381)
This test resets the TN802 MAPD circuit pack. The test is highly destructive and can be
initiated only by a reset board location command on the TN802 circuit pack.
This test runs on MEDPRO (Media Processor MAPD Circuit Pack).
Table 618: Windows 2000 Reset Test (#1381) 1 of 2
Error
Code
Test
Result
Description / Recommendation
2002 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 2
ABORT System resources required for this test are not available.
1. Retry reset board location at 1-minute intervals up to 5 times.
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack with busyout board location
2. Enter reset board location.
2100 ABORT System resources required for this test are not available.
1. Run reset board location at 1-minute intervals up to 5 times.
1 of 2