Server Alarms - Avaya Support

Table 438: Slip Alarm Inquiry Test (#144)
Error
Code
Test
Result
Description / Recommendation
Misframe Alarm Inquiry Test (#145)
Misframe Alarm Inquiry Test (#145)
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time.
1. Check the Error Log for Error Type 1538. If Error Type 1538
appears in the error log for this board, see Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module for the repair procedures.
Otherwise, retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 to 88 FAIL The DS1 board detected a slip alarm. The Error Code value is the
number of slips detected since the last slip alarm inquiry test.
1. Enter list measurement ds1-log location to read the
error seconds measurement.
2. If the DS1/UDS1 circuit pack or media module connects to a T1
network facility or to another switch, see T1 Network Facility
Procedures
0 NO
BOARD
3. If the DS1/UDS1 circuit pack or media module connects to a
line-side terminating device such as a PRI terminal adapter, see
Line-side Terminating Device Procedures
PASS No Slip Alarm is detected on the DS1 board.
See NO BOARD for the repair procedures.
A Misframe Alarm indicates that framing bits observed on a DS1 board are in error. The
Misframe Alarm Inquiry test queries the total number of misframes that have occurred on a DS1
board since the last inquiry.
If the DS1 board is supplying the system synchronization source when the threshold of
misframes is reached, a switching synchronization source message is sent to the TDM bus
Communication Manager Release 5.0 Issue 4 January 2008 1611