Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
The DS1 circuit pack, combined with the 120A CSU module or the 401A T1 sync splitter, forms
an Integrated CSU (ICSU).
If the 120A CSU module/T1 sync splitter is not installed, the status LEDs are always off and this
test aborts.
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MG-DS1 (DS1 Interface Media Module)
● UDS1-BD (UDS1 Interface Circuit Pack)
Table 585: ICSU Status LEDs Test (#1227) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT The ICSU Status LEDs test cannot be executed for the current
configuration. The test applies only to TN767E or later DS1 circuit packs
and TN464F or later UDS1 circuit packs administered for 24-channel
(1.544-Mbps) operation.
1. If the circuit pack is of the correct type, retry the command.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
1951 ABORT The ICSU Status LEDs Test cannot be executed because a 120A CSU
module or a 401A T1 sync splitter is not physically installed. If using a
120A CSU module/T1 sync splitter, physically connect it to the TN767 or
TN464 board on the back of the port carrier. Otherwise, ignore this abort.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1946 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2