Server Alarms - Avaya Support

LEDs
S8700 Server LEDs
The S8700 Server has an LED called Active/Standby which indicates whether the server is the
active server or the standby server. When the Active/Standby LED is on steadily, the server is
the active server. When the Active/Standby LED is flashing, this indicates that the server is the
standby server.
Figure 19: S8700 Server LEDs—Front and Back
Figure notes:
scdlled KLC 030502
1. Power
2. Configuration fault
3. Disk activity
4. Network activity (not used)
5. Service—configuration health (not
used)
6. Active or standby mode indicator
System shutdown LEDs
All server and Duplication Memory board LEDs are in the “off” state but still powered “on” when
the server is shut down.
Testing server LEDs
7. U2 (not used)
8. 4 NIC ports (the numbers indicate their
assigned Ethernet ports)
9. LEDs for the NIC ports
10. LEDs for fiber optic duplication
connectivity
11. Status LED (not used)
Using the Server Web interface, click Diagnostics > Test Server LEDs to ensure that the
Active/Standby LED on the server and the transmit LED on the Duplication Memory board are
controllable and not burned out, and that the server is not hung.
328 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2
1
1 2
1
SERVICE
ACTIVE
STANDBY
3 4 5 6 7
U2
DAI - 1
DUP
MEMORY
8
5 4 3 2
LINK
STAT
TRANS
RECEIVE
LINE
AVAYA
9
10
11