Server Alarms - Avaya Support

Table 431: DS1 Tie Trunk Seizure Test (#136) 3 of 3
Error
Code
Test
Result
DS1 Tie Trunk Seizure Test (#136)
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2053 ABORT
FAIL
At least one of the following errors is found in the Error Log for the DS1
circuit pack or media module:
● 1281 – Loss of Signal
● 1793 – Blue alarm
● 2049 – Red alarm
● 2305 – Yellow alarm
● 1537 – Hyperactivity.
1. Look for the above Error Types in the Error Log and follow the
procedures for DS1-BD (DS1 Interface Circuit Pack), UDS1-BD
(UDS1 Interface Circuit Pack), or MG-DS1 (DS1 Interface Media
Module) for the listed Error Types.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The far-end trunk did not respond to the seizure of the near-end trunk
within the allowed time.
1. If the affected port is located on a Media Module, replace the Media
Module.
2. Enter list configuration board location. If the circuit pack
is a TN767B vintage 8 or 9, replace the circuit pack with a TN767C V3
or later.
3. Verify that the Trunk Type field on the Trunk Group administration
form matches the trunk type administered on far-end switch.
4. Look for DS1-BD, UDS1-BD, or MG-DS1 errors in the error log. If any
are present, see DS1-BD (DS1 Interface Circuit Pack), UDS1-BD
(UDS1 Interface Circuit Pack), or MG-DS1 (DS1 Interface Media
Module) for repair procedures.
5. Retry the test at 1-minute intervals up to 5 times.
PASS The trunk can be seized for an outgoing call.
0 NO
BOARD
Description / Recommendation
See NO BOARD for the repair procedures.
3 of 3
Communication Manager Release 5.0 Issue 4 January 2008 1593