Server Alarms - Avaya Support

Table 384: Local Loop Test (#13) 9 of 9
Error
Code
Test
Result
Digital Station Lamp Update (#16)
Digital Station Lamp Update (#16)
PASS The Local Loop test passed. Every channel is transmitting properly.
1. To ensure that this is not an intermittent problem, repeat this test up
to 10 times and see if it continues to pass.
2. If the problem still exists, examine the connections, station, and
wiring.
This test lights all lamps on the terminal as specified. The lamp updates run only if the station is
in-service. The lamp updates are blocked from taking place if the station is not in the in-service
state. This test does not affect the status of the Message Waiting lamp.
This test runs on the following maintenance objects:
● DIG-IP-S (Digital IP Station)
● DIG-LINE (Digital Line)
Description / Recommendation
● E-DIG-ST (Emulated Digital Line)
● RC-BD (Radio Controller Board)
Table 385: Digital Station Lamp Update Test (#16) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
9 of 9
1 ABORT This port may have been busied out by a system technician.
1. Look in the Error Log for Error Type 18 (port busied out) for this port.
If this Error Type is present, release the port using the command
release station extension and run the test again.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
Communication Manager Release 5.0 Issue 4 January 2008 1473