Server Alarms - Avaya Support

Table 7: testdupboard command syntax
Syntax: testdupboard [-s | -l] | [-t arg] | [-?]
Argument Description
none Performs the Read Error Register Test.
Read Error Register Test
DAJ1/DAL1/DAL2 (Duplication Memory Board)
-s Short test. Performs the Read Error Register Test. This is also the default option
-l Performs the Read Error Register Test and the Duplication Memory Board Local
Loop Test
-t arg Specific test to perform. The values for arg are:
● read_err_reg to run the Read Error Register Test
● localloop to run the Duplication Memory Board Local Loop Test
-? Display the usage statement.
The following errors may occur:
1 Requested tests must be run on a busied out, standby server. Use the
server command to busyout a server.
3 Failed to create socket
Command could not allocate a system resource. Wait a minute, then try again.
4 Failed to connect to SME
Command could not connect to the server. Verify that both the Server
Maintenance Engine (SME) and Communication Manager are UP by entering
the command statapp on the server.
5 Failed to send request to SME
Request could not be sent to the server. Verify that both the Server Maintenance
Engine (SME) and Communication Manager are UP by entering the command
statapp on the server.
6 Failed to receive response from SME
The test did not receive a response from the server. Verify that both the Server
Maintenance Engine (SME) and Communication Manager are UP a by entering
the command statapp on the server.
The Read Error Register test queries three registers, then clears them. The registers are:
● Optical line receiver’s CRC error register
CRC errors indicate problems with the optical interface between the active and standby
servers.
Communication Manager Release 5.0 Issue 4 January 2008 55