Server Alarms - Avaya Support

Table 380: NPE Crosstalk Test (#6) 6 of 8
Error
Code
Test
Result
Description / Recommendation
NPE Crosstalk Test (#6)
1005 ABORT The test was aborted due to a configuration problem, such as when an analog
port is used in a combined modem pool. This error can be ignored.
1018 ABORT The test has been disabled by administration. Determine why this test was
disabled before enabling it.
1. To enable the test, enter change station extension for analog
stations and change trunk-group for trunks.
2. Enter y in the Maintenance Tests field and submit the screen.
3. Retry the command at 1-minute intervals up to 5 times.
1020 ABORT The test did not run due to a previously existing error on the specific port or
there is a more general circuit pack error.
1. Enter display errors and check the Error Log for existing errors
against this port or circuit pack. Attempt to diagnose the previously
existing error.
2. After resolving the previously existing errors, retry the command.
1117 ABORT A service state audit message is outstanding.
1. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
6 of 8
Communication Manager Release 5.0 Issue 4 January 2008 1447