Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 384: Local Loop Test (#13) 2 of 9
Error
Code
Test
Result
Description / Recommendation
1000 ABORT Could not seize the port. The port may be busy with a valid call.
ADX8D-PT, ADX16D-P, DIG-LINE and E-DIG-ST:
1. Enter display port location to determine the station
extension or attendant number of the port.
2. Enter status station extension or status attendant
extension to determine the service state of the port. If the port is
in use, wait until it is idle before retesting. Attendants are always in
use (off-hook) if the handset is plugged in and the port is not busied
out.
3. Retry the command at 1-minute intervals up to 5 times.
M/T-ANL:
1. To determine whether the port is in use by a valid ATMS test call,
enter status station ext where ext is the assigned ATMS
station’s number.
2. If the port is in use, wait until it is idle.
3. Retry the command at 1-minute intervals up to 3 times.
M/T-DIG:
1. Enter list isdnpri-testcall to determine which call is using
the port. Wait for the test call to complete as indicated in the Start
Time and Duration fields, or abort the test call with clear
isdnpri-testcall grp#/mem#, where grp#/mem# is
determined from the B-Channel field of list
isdnpri-testcall.
2. Retry the command at 1-minute intervals up to 5 times.
PDMODULE and TDMODULE:
1. Enter display port location to determine the data module
extension.
2. Enter status data module extension to determine the
service state of the data module. If the service state indicates that
the data module is in use, wait until the port is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1466 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 9