Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 558: Packet Interface Reset Test (#889) 3 of 3
Error
Code
Test
Result
PASS The IPSI’s Packet Interface diagnostic software passed. The Packet
Interface is put back into service automatically.
NO
BOARD
Description / Recommendation
The IPSI circuit pack’s Packet Interface module is assigned but is not
detected as physically present.
1. If the IPSI circuit pack is present, replace it.
2. If not, insert a TN2312AP IPSI circuit pack in the assigned slot, and
rerun the test.
Signaling Port LAN Loopback Test (#939)
This test is destructive.
This test verifies the connectivity of an ISDN-PRI signaling port (D-Channel) across the packet
bus, also known as the LAN bus. It will run only if the port is out of service. Failure of this test
indicates a fault associated with the port hardware on the circuit pack.
This test runs on ISDN-PLK (ISDN-PRI Signaling Link Port).
Table 559: Signaling Port LAN Loopback Test (#939) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1015 ABORT The port is not in the out-of-service state. Enter busyout port
location to place it in the out-of-service state and repeat this test.
CAUTION: The
! CAUTION:
busyout prevents new call originations on every
B-Channel in the signaling group until the port is
released.
1890 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
3 of 3
1 of 2