Server Alarms - Avaya Support

Modem Pool Conference Test (#97)
Modem Pool Conference Test (#97)
This test is destructive.
The Modem Pool Conference Test checks most of the switching and gain control functions
provided by the NPE circuit in the analog section of the conversion resource. This test
conferences a 1004-Hz tone through the NPE, looping it back so that it can be verified with a
Tone Detector circuit
This test runs on MODEM-PT (Modem Pool Port).
Table 415: Modem Pool Conference Test (#97) 1 of 4
Error
Code
Test
Result
Description / Recommendation
ABORT System resources required for this test are not available.
1. Determine whether the port is available for testing.
2. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be in use on a valid call.
1. Determine whether the port is available for testing.
2. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1 of 4
Communication Manager Release 5.0 Issue 4 January 2008 1549