Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 533: FIBER-LK Configuration Audit (#759) 7 of 9
Error
Code
Test
Result
Description / Recommendation
212 FAIL The SNI circuit pack cannot communicate with the active SNC.
1. Check the error log for other SNI circuit packs in the same carrier with
an SNI-BD error for Error Type 257. Enter display errors with
category PNC to view SNI-BD errors. If other SNI circuit packs in the
same switch node carrier have error 257, then replace the active SNC
in this switch node carrier. Replacing an SNC may be service
interrupting. Refer to SNC-BD (Switch Node Clock Circuit Pack) for
the procedure for replacing an SNC.
2. Replace this SNI. Refer to SNI-BD (SNI Circuit Pack) for the
procedure.
3. Replace the active SNC in the same switch node carrier.
233 FAIL No neighbor link is assigned, but the SNI (Endpoint 2) has an EI neighbor.
1. Enter list fiber-link to display a fiber link’s endpoints.
If the SNI should have an EI neighbor:
1. Enter add fiber-link next to assign the fiber link’s SNI to its
physically connected EI neighbor.
If not:
2. Remove both fiber endpoints (i.e., this SNI and its EI neighbor).
3. Enter change circuit-pack to remove the fiber endpoints from
circuit-pack administration.
234 FAIL No neighbor link is administered, but the SNI (Endpoint 2) has an SNI
neighbor.
1. Enter list fiber-link to display a fiber link’s endpoints.
2. Administer the SNI on a fiber link to the SNI neighbor it is connected
to via add fiber-link next. Or remove both fiber endpoints (i.e.,
this SNI and its SNI neighbor) and remove the fiber endpoints from
circuit pack administration via change circuit-pack.
1816 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
7 of 9