Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
This test runs on PPP-PT (Control LAN Packet/Port) and VAL-PT (Voice Announcements over
LAN Packet/Port).
Table 596: SCOTCH Synchronous Looparound Test (#1275)
Error
Code
Test
Result
Description / Recommendation
1000 ABORT The port is in use.
1. Retry the command when the port is idle, or use busyout port
location to force the port to the idle state.
Note: This command is destructive, causing every call and link using the
port to be torn down.
1002 ABORT No TDM bus time slots available for the test.
1. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
1963 ABORT The port is in use.
1. Retry the command when the port is idle, or use busyout port
location to force the port to the idle state.
Note: This command is destructive, causing every call and link using the
port to be torn down.
2000 ABORT Did not receive test response within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times. If this problem
persists, reset the circuit pack and rerun the test.
2. If the problem persists, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The VAL or C-LAN circuit pack detected a test failure.
1. Retry the command at 1-minute intervals up to 5 times. If the problem
persists, reset the circuit pack and rerun the test.
2. If the problem persists, replace the circuit pack.
PASS Port circuitry is functioning properly.
1966 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers