Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
b. Error Type 1: DS1 Interface circuit pack or media module detects a hardware error on the
DS1 DID trunk. The Aux Data field indicates the following:
57476 On-hook before wink
57477 On-hook before ready to receive digits
57485 Wink too short for valid signal
Maintenance does not start any testing or generate any alarms in response to these errors.
c. Error Type 15: Software audit error that does not indicate hardware malfunction. Run short
test sequence, and investigate any errors.
d. Error Type 18: The trunk has been taken out of service by a demand busyout. No calls can
be made on this trunk.
e. Error Type 130: the circuit pack or media module has been removed or has been insane for
more than 11 minutes. To clear the error, reinsert or replace the circuit pack or media
module.
f. Error Type 257: DS1 Interface circuit pack or media module detects a hardware error on
the DS1 DID trunk. The Aux Data field indicate the source of the error:
57473 Rotary dial rate above 8 pulses per second
57474 Rotary dial rate below 12 pulses per second
g. Error Type 513: DS1 Interface circuit pack or media module detects a hardware error on
the DS1 DID trunk. Aux Data 57392 indicates no external release on PBX disconnect.
h. Error Type 769: DS1 Interface circuit pack or media module detects a hardware error on
the DS1 DID trunk. Aux Data 57393 indicates belated external release on PBX disconnect.
i. Error Type 1793: DS1 Interface circuit pack or media module is out-of-service. Look in the
error log:
If port is on Look in
TN767 DS1 Board DS1-BD
TN464 UDS1 Board UDS1-BD
DS1 Interface Media Module MG-DS1
j. Error Type 2305 indicates that a signaling change was detected by the PBX trunk circuit
pack or media module which is inconsistent with the present state of the trunk.
k. Error Type 3840: Port Audit and Update test (#36) failed due to an internal system error.
Enter status trunk to verify the status of the trunk. If the trunk is out-of-service, enter
release trunk to put it back to in-service. Retry the test command.
680 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers