Server Alarms - Avaya Support

● ASAI-PT (ASAI Port)
● BRI-PORT (ISDN-BRI Port)
● TBRI-PT (ISDN Trunk-Side BRI Port)
Table 515: Receive FIFO Error Counter Test (#625)
Error
Code
Test
Result
Description / Recommendation
Signaling Link Status Test (#626)
Signaling Link Status Test (#626)
2000 ABORT Response to the test was not received within the allowed time.
1. If the test aborts repeatedly up to 5 times, reset the circuit pack and
rerun the test.
2. If the test aborts again, replace the circuit pack.
2012 ABORT Internal system error.
2100 ABORT Could not allocate necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The circuit pack is still detecting errors of this type. The Error Code field
contains the value of this counter.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, review the results of other tests in the long
test sequence. Note the results of the Receive FIFO Error Counter
test. Follow repair procedures for any of the tests that fail. Otherwise,
go to the next step.
3. If the tests for the endpoints or adjunct pass and the Receive FIFO
Error Counter test continues to fail, check the wiring to the endpoints
or adjunct.
PASS The Receive FIFO error counter has a value of 0.
This test determines the current status of the signaling link. This test passes if the link is “bound”
to an endpoint and fails if the link is “not bound.”
The definition of the term “bound” for a link depends upon the type of endpoint and may depend
on the successful completion of procedures at both Layers 2 and 3 of the protocol. The
definition of “bound” for each type of endpoint is as follows:
● BRI endpoints administered for MIM (management information messages) initialization
(multipoint):
Communication Manager Release 5.0 Issue 4 January 2008 1763