09.12.2012 Views

Server Alarms - Avaya Support

Server Alarms - Avaya Support

Server Alarms - Avaya Support

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Communication Manager Maintenance Object Repair Procedures<br />

Table 392: Tone Detection Verification Test (#42) 1 of 3<br />

Error<br />

Code<br />

Test<br />

Result<br />

Description / Recommendation<br />

ABORT The system was not able to allocate resources needed for this test,<br />

OR there was an internal system error.<br />

1. Retry the command at 1-minute intervals up to 5 times.<br />

1 ABORT The system could not allocate resources needed to test the tones.<br />

1. Retry the command at 1-minute intervals up to 5 times.<br />

1001 ABORT The system was unable to seize the port to test it.<br />

1. Retry the command at 1-minute intervals up to 5 times.<br />

1002 ABORT The system could not allocate time slots for the test. The system may<br />

be under heavy traffic conditions, or it may have time slots<br />

out-of-service due to TDM-BUS errors. A system is considered under<br />

heavy traffic when the Call Processing Occupancy is greater than<br />

50% or when the System Management and the Call Processing<br />

Occupancies together exceed 65%.<br />

1. Enter status health to view the occupancy measurements.<br />

2. Enter display errors and resolve any TDM-BUS (TDM Bus)<br />

errors.<br />

3. If the system has no TDM-BUS errors and is not handling heavy<br />

traffic, retry the command at 1-minute intervals up to 5 times.<br />

1003 ABORT The system could not allocate a Tone-Clock for the test connection.<br />

This may be caused by a heavy load on the system or by a faulted<br />

Tone-Clock.<br />

1. Check to see if there are any alarms against the TONE-BD or<br />

TONE-PT in the PN where the test aborted. If so, see TONE-BD<br />

(Tone-Clock Circuit Pack) and TONE-PT (Tone Generator) for<br />

recommended procedures.<br />

2. If a new Tone-Clock has been inserted, allow about 1-minute for<br />

the system to initialize the newly inserted circuit pack.<br />

3. Retry the command at 1-minute intervals up to 5 times.<br />

1412 ABORT This test does not run on media modules or media gateways. Ignore.<br />

2000 ABORT Response from the test was not received within the time allowed.<br />

1. Retry the command at 1-minute intervals up to 5 times.<br />

1498 Maintenance <strong>Alarms</strong> for <strong>Avaya</strong> Communication Manager, Media Gateways and <strong>Server</strong>s<br />

1 of 3

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!