Server Alarms - Avaya Support

Chapter 6: Maintenance Demand Tests
Dial Tone Test (#0)
The Dial Tone Test attempts to seize a port and check for the return of a dial tone. It is run for
CO-TRK (Analog CO Trunk) and DIOD-TRK (DIOD Trunk).
Table 377: Dial Tone Test (#0) 1 of 4
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call.
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service state of the port. If
the service state indicates that the port is in use, wait until the port is
idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT System resources required to run this test were not available.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1 of 4
Communication Manager Release 5.0 Issue 4 January 2008 1429