Server Alarms - Avaya Support

Table 498: Expansion Interface Packet Interface Test (#589) 4 of 5
Error
Code
Test
Result
Description / Recommendation
Expansion Interface Packet Interface Test (#589)
1421 ABORT This abort code appears only when the EI circuit pack addressed in the
test command is one that terminates a fiber link between two PNs in a
direct connect system. It indicates that the test failed, but that this test
was run on the PN EI board that is: a) in the same PN as the board under
test b) on the active PNC (if duplicated) c) terminates the fiber from the
PN. The EI tested is probably not at fault.
1. Enter display alarms and follow the EXP-INTF repair procedures
for any alarms against the PN EI that is:
a. In the same PN as the board just tested
b. On the active PNC
c. Terminates the fiber link from the PN
2. If there are no alarms logged against that EI, run Test #589 on it and
follow procedures for this test.
3. Run this test again.
1422 ABORT This abort code is valid and will only appear when the EI circuit pack
under test resides in a PN of a system with a Center Stage Switch
configuration. It means that the test failed, but that this test was then run
on the PN EI on the same PNC as the EI under test and that test failed.
This means that the EI originally tested is probably not at fault.
1. Resolve any alarms that are logged against the PN EI that is on the
same PNC as the EI under test.
2. If there are no alarms logged against the PN EI, run Test #589 against
the PN EI and follow procedures for this test.
3. Run this test again.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
2060 ABORT The link on the packet bus being used to perform the test has failed.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the test continues to abort, enter display errors and resolve
any PKT-INT errors.
4 of 5
Communication Manager Release 5.0 Issue 4 January 2008 1733