Demand test descriptions and error codes - Avaya Support

Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: this error indicates the circuit pack totally stopped functioning or it was
physically removed from the system.
Note: The
Note:
alarm is logged approximately 11 minutes after the circuit pack is removed/
SAKI Sanity test (#53) fails.
If the circuit pack is not present in the system, insert a circuit pack in the slot indicated by
the error to resolve the error.
If the circuit pack is present in the system, it is faulty and must be replaced. See Replacing
the IPSI or Tone-Clock Circuit Pack.
If the faulty circuit pack is in standby mode, a MINOR alarm is raised, but no other system
action is taken. If the circuit pack is the active Tone-Clock, further effects of this error
depend on the system’s reliability option.
Table 269: Effects of Tone-Clock Failures Depending on Reliability MTAR
Reliability Option Effects
Standard EPN goes down
Duplex PN goes down.
High IPSI interchange in IPSI connected PN
non IPSI connected PN goes down
Critical IPSI interchange in IPSI connected PN
Interchange to standby Tone-Clock circuit pack in non IPSI
connected PN
If an interchange is attempted in an MCC PN and the system is unable to activate the
standby Tone-Clock, Emergency Transfer is activated. When this happens, both circuit
packs are faulty and must be replaced. See Replacing the IPSI or Tone-Clock Circuit Pack.
If a successful interchange occurs in response to a failure of the active Tone-Clock or if a
standby Tone-Clock fails, the faulty Tone-Clock should be replaced.
c. Error Type 18: the indicated IPSI or Tone-Clock circuit pack has been made unavailable by
busyout tone-clock location or busyout ipserver-interface location.
This error applies only to high- or critical-reliability systems (an active Tone-Clock may not
be busied out). To resolve this error, enter release tone-clock location, or
release ipserver-interface location.
1004 Maintenance Alarms for Communication Manager, Media Gateways and Servers