Demand test descriptions and error codes - Avaya Support

Table 79: DAT-LINE Error Log Entries 2 of 2
Error
Type
Aux
Data
Associated Test Alarm
Level
15(b) Any Port Audit and
Update (#36)
18 0 busyout port
location
WRN OFF rel port location
130 (c) WRN ON test port location
257 Conference
Circuit Test (#7)
513 NPE Crosstalk
Test (#6)
769(d) 40983
On/Off
Board
Recommended Action
MIN ON test port location l r 2
MIN ON test port location l r 2
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its recommended procedures.
b. Error Type 15: Software audit error that does not indicate any hardware malfunction. Run
the short test sequence, and investigate errors.
c. Error Type 130: The circuit pack has been removed or has been insane for more than
11-minutes. To clear the error, reseat or replace the circuit pack.
d. Error Type 769: the data line circuit pack found an error in the transmit/receive circuitry of
an administered data line when the circuit pack was inserted. Perform the following:
1. Enter busyout board location for the circuit pack on which the port resides.
2. Enter reset board location. Check the Error Log to determine whether Error
Type #769 is logged again for DAT-LINE. Verify that the Active Alarms Only field is n.
If Error Type #769 reappears, replace the data line circuit pack. If not, enter
release board location.
298 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2