19.12.2012 Views

Demand test descriptions and error codes - Avaya Support

Demand test descriptions and error codes - Avaya Support

Demand test descriptions and error codes - Avaya Support

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Maintenance <strong>Dem<strong>and</strong></strong> Tests<br />

If a Loss Of Signal alarm <strong>and</strong> an I-CSU/Sync Splitter <strong>error</strong> coexist, the Loss Of Signal alarm<br />

condition takes priority, <strong>and</strong> the board <strong>and</strong> all of its trunks are put in the out-of-service state.<br />

Errors are logged for both.<br />

When the system receives notification that the I-CSU/Sync Splitter hardware <strong>error</strong> condition no<br />

longer exists, maintenance restores the board <strong>and</strong> its trunks to their previous service state if the<br />

alarm can be cleared (no other I-CSU/Sync Splitter <strong>error</strong>s or Loss Of Signal alarms exist).<br />

Table 337: Loss of Signal Alarm Inquiry Test (#138) 1 of 7<br />

Error<br />

Code<br />

Test<br />

Result<br />

Description / Recommendation<br />

ABORT Internal system <strong>error</strong><br />

1. Retry the comm<strong>and</strong> at 1-minute intervals up to 5 times.<br />

2000 ABORT Response to the <strong>test</strong> was not received within the allowed time. This may<br />

be due to hyperactivity.<br />

1. Enter display <strong>error</strong>s on the SAT.<br />

2. Check for Error Type 1538 for this DS1 board. If Error Type 1538<br />

appears in the <strong>error</strong> log for this board, see Hyperactive DS1/UDS1<br />

Interface Circuit Pack/Media Module for the repair procedures.<br />

Otherwise, retry the <strong>test</strong> at 1-minute intervals up to 5 times.<br />

2100 ABORT Could not allocate the necessary system resources to run this <strong>test</strong>.<br />

1. Retry the comm<strong>and</strong> at 1-minute intervals up to 5 times.<br />

FAIL The board detects a Loss of Signal alarm. The physical link is broken or<br />

the remote DS1 endpoint is down. All trunks or ports of this board are<br />

out-of-service.<br />

Note: If<br />

Note:<br />

a DS1/UDS1 circuit pack is designated as the supplier of<br />

the system synchronization source, the system<br />

synchronization maintenance adopts a source elsewhere.<br />

See SYNC (Port Network Synchronization) for details.<br />

1. If the DS1/UDS1 circuit pack or media module connects to a T1<br />

network facility or to another switch, see T1 Network Facility<br />

Procedures<br />

2. If the DS1/UDS1 circuit pack or media module connects to a<br />

line-side terminating device such as a PRI terminal adapter, see<br />

Line-side Terminating Device Procedures<br />

1238 Maintenance Alarms for Communication Manager, Media Gateways <strong>and</strong> Servers<br />

1 of 7

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!