Demand test descriptions and error codes - Avaya Support

SNC On-Board Test (#778)
This test runs on the SNC-BD (Switch Node Clock Circuit Pack) maintenance object.
Table 446: SNC On-Board Test (#778) 1 of 2
Error
Code
2100
2300
2301
2303
2304
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
The downlink message necessary to run this test could not be sent.
The timer could not be set before sending the downlink message.
Test request is not valid.
SNC firmware is not able to run the test.
1. Retry the command at 1-minute intervals up to 3 times.
2306 ABORT The SNC circuit pack is not responding to test requests sent by
software.
1. Run test led switch-node for the switch node where this
board resides to verify whether the LEDs on the board light.
2. If the LEDs on the other boards in the carrier light, but the LEDs
on this board do not light, run Test #760 using test board
location l for the active SNC in this carrier. Wait 5 minutes
and then try step 1 one more time. If the LEDs on this board still
do not light, replace this board. Replacing an SNC may be
service interrupting. See SNI-BD (SNI Circuit Pack) for the
procedure for replacing an SNC.
3. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this
carrier to the server.
a. Enter list fiber-link to obtain a list of the fiber
connections to this carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber
problems.
c. Enter display errors, and follow the repair procedures
for any EXP-INTF (Expansion Interface Circuit Pack) error
entries associated with the controlling IPSI connected PN.
d. Follow the repair procedures for any SYNC (Port Network
Synchronization), SNI-BD (SNI Circuit Pack), SNC-BD
(Switch Node Clock Circuit Pack) SNI-PEER (SNI Peer Link)
or FIBER-LK (Fiber Link) error entries.
1 of 2
Issue 5 May 2009 1493