Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 453: DS1C Board Options Audit (#795) 2 of 2
Error
Code
Test
Result
105 ABORT The neighbor DS1C circuit pack at the other end of the DS1C complex is
not accessible.
1. Retry the command at 1-minute intervals up to 3 times.
2. The link at the other end of the DS1C complex may be down. Enter
display errors and follow the associated repair procedures for
any DS1C-BD (DS1 Converter Circuit Pack) and DS1-FAC (DS1
Facility) errors.
3. If the test still aborts, escalate the problem.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Required system resources to run this test are not available.
1. Retry the command at 1-minute intervals up to 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The timer could not be set before sending the test downlink message.
1. Retry the command at 1-minute intervals up to 3 times.
2316 ABORT Fiber link is not administered.
1. Administer the DS1C fiber link using add fiber-link.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
0 NO
BOARD
PASS The options were successfully sent to the DS1C circuit pack.
Far-End Internal Loopback Test (#797)
This test is destructive.
Description / Recommendation
See NO BOARD for the repair procedures.
1512 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2