Demand test descriptions and error codes - Avaya Support

Neon Test (#220)
Neon Test (#220)
This test checks the voltage required to light the neon lamp on an analog terminal. A relay
connects a 150V DC source from the backplane of the circuit pack onto the voltage bus, and
another relay connects a 2K shunt from the bus to ground. Current in the line is then monitored
to determine if the voltage is present.
This test runs on XXX-BD (Common Port Circuit Pack/Media Module).
Table 369: Neon Test (#220) 1 of 3
Error
Code
Test
Result
Description / Recommendation
ABORT Cot get the list of translated ports on the circuit pack.
1. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display port location to determine the station
extension.
2. Enter status station to determine the service state of the port.
If the service state indicates that the port is in use, wait until the
port is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1008 ABORT Could not allocate a ringing circuit. Either all the ringing circuits are in
use, or the ringing generator is defective or is not wired correctly.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, look for RING-GEN errors in the Error
Log. If an ABORT 1008 occurs for this test on other circuit packs as
well, then the ringing generator may be defective or is not wired
correctly (see errors for RING-GEN (Analog Ring Generator)). If
ABORT 1008 does not occur on Test #48 for ANL-16-L, then all
four ring phases are in use.
1 of 3
Issue 5 May 2009 1301