Demand test descriptions and error codes - Avaya Support

Note: Near
SIP-SGRP (SIP Signaling Group)
adequate transmission of voice. If the signaling group has been administered to enable
BYPASS, then Error Type 1025 also occurs.
g. Error Type 1025: the signaling group has been placed into a BYPASS condition because of
IP network congestion. The signaling group accepts incoming calls, but every outgoing call
is denied. The system routes these calls over a secondary route, if one has been
administered.
h. Error Type 1281: No medpro resources are in service to provide media connections for the
trunk members of the signaling group.
Check for errors against the MEDPRO and MEDPROPT maintenance objects. This error
causes all SIP B-Chels to be in an out-of-service near-end state.
i. Error Type 1537: The far end of the signaling group is not ready to handle audio bearer. If
the other end of this signaling group is also a Communication Manager server, this error
means the server on the other end does not have MEDPRO in-service for its signaling
group.
This error places the SIP B-Chels into an out-of-service far-end state.
j. Error Type 1794: The Signaling Group reported that the far end has detected excessive
packet latency or loss. This error places the SIP B-Chels into an out of service far-end state.
k. Error Type 2561: The signaling group is registered to an LSP.
l. Error Type 3073: A TLS connection was established with the far-end but authentication
with the far-end’s TLS certificate failed. Due to this condition, the signaling group will be
placed in far-end bypass state so that no outgoing calls will be allowed,. The trunks in the
group will be placed in an out of service far end state (OOSFE). Incoming calls will be
accepted, but until the far-end’s TLS certificate is remedied, these will not be successful.
Once the far-end’s certificate is remedied, an incoming call can succeed and the trunk
group will be put back in service.
m. Error Type 3329: The near end TLS certificate is bad. The trunks in the group will be placed
in a near end out of service state and the signaling group will be placed in bypass. No trunk
calls either incoming or outgoing will be allowed until the near end’s certificate is corrected.
The system is warm started (reset system 1), and the signaling groups go through a busy/
release action. If the near end certificate is bad, listen sockets fro the signaling group will
not be created, so this alarm is raised at the creation of the listen socket stage (i.e., when
initially bringing the signaling group into service).
Note:
end certificate authentication is the process of validating that the server
certificate is OK, i.e., we have the private key and the certificate is trusted. This
will only break if a user with root access has changed the certificate private key
file.
n. Error Type 3585: IP Signaling Far-end Status Test failed. The far-end is not available. See
IP Signaling Group Far-End Status Test (#1675) for more information.
Issue 5 May 2009 831