Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 457: Automatic Transmission Test (#844-848) 5 of 5
Error
Code
Test
Result
Description / Recommendation
8000 FAIL Measured transmission performance was in the marginal range as
administered on the trunk group screen. This generally means that the
trunk is usable but has an undesirable amount of noise or loss. If the user
does not report unacceptable effects, it may not be necessary to take any
action.
1. Retrieve a measurement report using list testcalls.
2. Make sure that ATMS thresholds are set properly on page 4 of the
Trunk Group screen.
3. Besides the facility, test failures can be caused by faulty test lines or
switch paths. If the measurements point to a facility problem, report
the results to the trunk vendor.
PASS The measured transmission performance was in the acceptable range.
Packet Interface Memory Checksum Test (#884)
This test sends a message to the Packet Interface module to run memory checksum tests on
the Boot PROM and FLASH memory on the IPSI circuit pack. If the test fails, the Packet
Interface module remains operational until a reset is executed. The Packet Interface is then
placed in an out-of-service state.
This test runs on PKT-INT (Packet Interface).
Table 458: Packet Interface Memory Checksum Test (#884) 1 of 4
Error
Code
1006
1137
Test
Result
Description / Recommendation
1524 Maintenance Alarms for Communication Manager, Media Gateways and Servers
5 of 5
ABORT Because the IPSI’s Packet Interface module is out of service, normal
maintenance tests do not run on the Packet Interface.
1. Enter reset packet-interface location to reset the Packet
Interface. See Packet Interface Reset Test (#889).
1 of 4