Demand test descriptions and error codes - Avaya Support

Table 510: ATM Crosstalk Test (#1298) 3 of 3
Error
Code
Test
Result
Description / Recommendation
RC NPE Port Audit Test (#1315)
RC NPE Port Audit Test (#1315)
1–8 PASS The board is talking to authorized time slots on the TDM Bus. The error
code indicates the number of TALKER DSPs that were tested.
This tests executes the NPE crosstalk test on a Radio controller (RC) NPE port. If the test is
unsuccessful, the port number (1-24) of the RC NPE port which failed is returned.
Not all ports are tested, as this would take an excessive amount of time. It is most likely that if
one port fails, then all of the ports are bad. To test all 24 RC NPE ports, use the repeat 24
option for the test board command. This test is run on RC-BD (Radio Controller Board).
Table 511: RC NPE Port Audit Test (#1315) 1 of 2
Error
Code
Test
Result
Description / Recommendation
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
3 of 3
1-24 ABORT The Error Code identifies the NPE for which the test aborted. The NPE
is probably being allocated for a call.
1. Enter status radio-controller loc to verify there are no
calls on the RC circuit pack.
2. If not, retry the command at one-minute intervals up to 5 times.
3. If the test continues to abort, escalate the problem.
1 of 2
Issue 5 May 2009 1637