Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 475: VC DSP Port DSP Looparound Test (#1105) 2 of 3
Error
Code
1002 ABORT The system could not allocate time slots for the test. The system may
be under heavy traffic conditions, or it may have time slots
out-of-service due to TDM-BUS errors. A system is considered under
heavy traffic when the Call Processing Occupancy is greater than 50%
or when the System Management and the Call Processing Occupancies
together exceed 65%.
1. Enter status health to view the occupancy measurements
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see
information regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port has been seized by a user for a valid call. Enter status
station for the station associated with this port and determine
whether the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time.
1. If this result occurs repeatedly, reset the circuit pack if the other
ports are idle with busyout port location,
reset port location, and release port location.
2. If this result occurs again, replace the circuit pack.
2012
2100
Test
Result
Description / Recommendation
ABORT Internal system error.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1566 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3