Demand test descriptions and error codes - Avaya Support

Far-End DS1 Converter Circuit Pack Loopback Test (#788)
Table 450: Far-End DS1 Converter Circuit Pack Loopback Test (#788) 2 of 3
Error
Code
Test
Result
Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2300 ABORT The downlink message could not be sent to the selected DS1C board.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The timer could not be set before sending the downlink message.
1. Retry the command at 1-minute intervals up to 3 times.
2316 ABORT Fiber link is not administered.
1. Administer the DS1 converter fiber link with add fiber-link and
rerun the test.
2321 ABORT DS1 converter circuit pack is not busied out.
1. Busyout the DS1 converter circuit pack with busyout board.
2332 ABORT With this system configuration (unduplicated PNC), the test cot run at the
far end when there is only one DS1-FAC available. The link would be lost,
and no test results would be seen at the server. Run the test at the other
end of the DS1C complex.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
2 of 3
Issue 5 May 2009 1503