Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 379: Signaling Link State Audit Test (#255) 1 of 2
Error
Code
None
or 0
Test
Result
Description / Recommendation
ABORT Internal system error.
1. Retry the command up to 5 times at 1-minute intervals.
1018 ABORT Test is disabled by administration.
1. To enable the test, enter y in the Maintenance Tests field on the
change trunk-group screen.
1114 ABORT The signaling link is in a transitional state
1. Retry the command up to 5 times at 1-minute intervals.
1700 ABORT Rollabout video abort for PE-BCHL. The PRI terminal adapter
associated with this PRI endpoint extension is detached from the circuit
pack. This is a normal abort when the rollabout video feature is enabled.
1. Either reconnect the disconnected PRI terminal adapter or disable
the rollabout video feature on this circuit pack. To do the latter,
enter change ds1 location and set the Alarm when PRI
Endpoint Detached? field to y.
4 FAIL There is a problem with the signaling chel.
ATM-BCH:
1. Look for errors or alarms against ATM-SGRP and ATM-DCH, and
refer to ATM-SGRP (ATM Signaling Group) and ATM-DCH (ATM
D-Chel Port) for the appropriate repair procedures.
ISDN-TRK:
1. If the Packet Control circuit pack is used, consult the procedures
for ISDN-SGR (ISDN-PRI Signaling Group). Further information
may also be obtained by consulting the procedures for the
ISDN-PLK (ISDN-PRI Signaling Link Port).
2. If the Packet Interface is used, consult the procedures for PKT-INT
(Packet Interface)
PE-BCH: There is a problem with the Signaling Chel and/or with the
System Link.
1. Consult procedures for ISDN-SGR (ISDN-PRI Signaling Group)
and SYS-LINK (System Links). See also ISDN-PLK (ISDN-PRI
Signaling Link Port) for useful information.
1330 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2