Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 377: Expansion Interface Lightwave Transceiver Looparound Test (#242) 3 of 5
Error
Code
Test
Result
Description / Recommendation
1395 ABORT This test cot be run on an EI circuit pack if it is part of the B-side PNC and
duplicated PNC is not enabled.
1. If this test needs to run on this EI circuit pack, enable PNC with
change system-parameters duplication.
2. Enter set pnc lock to prevent the system from doing a PNC
interchange.
3. Repeat this test.
1407 ABORT This test cot be run on an EI board that is on the active PNC because it
cot be busied out. This error code indicates that PNC duplication is
enabled.
1. Attempt to perform a PNC interchange with
reset pnc interchange.
2. If the PNC interchange is successful, busyout the original EI circuit
pack with busyout board location (location of the original EI
board).
3. Retry the command.
2000 ABORT Response to the test was not received in the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
2060 ABORT The link on the packet bus being used to perform the test has failed.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the test continue to abort, enter display errors and resolve
any PKT-INT errors.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1326 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 5