Demand test descriptions and error codes - Avaya Support

Note: 2561–2668
VAL-BD (Voice announcements over LAN Circuit Pack)
l. Error Type 2305-2306: error in received frame from packet bus. Most likely a packet bus
problem.
Error Type 2305 - Received invalid LAPD frame.
Error Type 2306 - Detected parity error on received frame
Invalid LAPD frame errors occur when the frame:
● contains a bad Cyclic Redundancy Check (CRC)
● is greater than the maximum length
● violates the link-level protocol
1. Run test board location and see if the condition clears.
2. If the condition persists, execute the Invalid LAPD Frame Error Counter Test (#597)
and determine whether the condition clears.
3. If the condition persists, execute the Packet Interface Test (#598) to verify circuit pack
integrity.
4. If the Packet Interface test (#598) fails, see PKT-BUS (Packet Bus) for repair
procedures.
m. Error Type 2561–2668: system software received an indication that the socket was closed
due to an error. Errors are reported as log only. Errors logged here are for the sockets that
had no processor chels associated with them, for example, sockets to read SNMP data.
The counter base is offset by the application type of the application associated with this
socket that is down. The Aux Data field of the log entry contains this application’s number,
for example, a SNMP application would have its application number in the Aux Data field.
Note:
is a range of reserved numbers for future applications. 2570 currently
represents an SNMP socket failure.
n. Error Type 2817–2819: Congestion Query test (#600) failed.
Error Type 2817 - Every buffer exhausted
Error Type 2819 - Utilized buffers exceed threshold
See Congestion Query Test (#600) for repair procedures.
o. Error Type 3073: Remote Socket Control Link (RSCL) or Link Status Test (#601) failed.
This failure can be due to:
● This circuit pack
● The packet bus
● The packet interface circuit pack.
If: Then:
Issue 5 May 2009 1045