Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 438: FIBER-LK Configuration Audit (#759) 5 of 10
Error
Code
Test
Result
Description / Recommendation
137 FAIL The Endpoint 1 SNI’s administered neighbor does not match the physical
neighbor connected.
1. Enter list fiber-link to see a fiber link’s endpoints. The SNI’s
assigned neighbor is an EI, but the SNI is physically connected to
another SNI.
2. Enter list fiber-link and verify that the fiber-optic and metallic
cables are installed as administered.
138 FAIL The physical location of SNI Endpoint 1’s neighbor does not match its
administered location.
1. Enter list fiber-link to see a fiber link’s endpoints. One
location (carrier and slot) is assigned for the endpoint’s neighbor, but
it physically resides in another location.
2. Enter list fiber-link and verify that the fiber-optic and metallic
cables are installed as administered.
3. If the problem does not seem to be caused by either a physical
connection or an administration problem, replace the neighbor circuit
pack. The neighbor circuit pack may have a hardware problem
causing it to report a wrong Angel address (physical carrier/slot
address) to software.
139 FAIL The Endpoint 1 SNI is administered to be connected to a DS1 converter,
but is not physically connected to one.
1. Enter list fiber-link to see a fiber link’s endpoints.
If a DS1 converter should be connected to this SNI, enter list
fiber-link and verify that the fiber-optic and/or metallic cables are
installed as assigned.
If not, change administration to remove the DS1 converter complex from
the SNI’s fiber link:
1. Enter list fiber-link to locate the fiber with this SNI as an
endpoint
2. Enter remove fiber-link to remove the fiber
3. Enter add fiber-link to add the fiber back, without assigning the
DS1 converter complex
1464 Maintenance Alarms for Communication Manager, Media Gateways and Servers
5 of 10