Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Ethernet Local Looparound Test (#1278)
This test checks the circuitry in the data path for an Ethernet call from the on-board processor to
the Ethernet Transceiver. This test fails if the received data does not match the transmitted data.
This test runs on ETH-PT (Control LAN Ethernet).
Table 502: Ethernet Local Looparound Test (#1278)
Error
Code
Test
Result
Description / Recommendation
1000 ABORT The port is in use.
1. Determine status of port using status clan-port location.
2. Retry the command when the port is idle. You can force the port to
the idle state by executing busyout port location.
Note: The busyout port command is destructive, causing every call
and link associated with the port to be torn down.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, reset the circuit pack.
3. Retry the command at 1-minute intervals up to 5 times.
4. If the problem persists, replace the circuit pack.
2012
2100
ABORT Internal system error.
Could not allocate the necessary resources to run the test.
1. Retry the command at 1-minute intervals, up to 3 times.
2. If the problem persists, escalate the problem.
1 FAIL Data received did not match the data transmitted.
1. Reset the circuit pack.
2. Retest the circuit pack with test board location long
3. If the problem persists, replace the circuit pack.
PASS The circuitry is functioning properly.
1620 Maintenance Alarms for Communication Manager, Media Gateways and Servers