Demand test descriptions and error codes - Avaya Support

o. Error Type 3840-4095: Certain ISDN-BRI cause codes are logged by switch software. The
cause code can be determined from the following formula:
If the Error Type is greater than 3968, then the ISDN-BRI cause code is equal to the Error
Type minus 3968. This code was sent to the endpoint by the switch.
If the Error Type is less than 3968, then the ISDN-BRI cause code is equal to the Error
Type minus 3840. This code was sent to the switch by the endpoint.
A description of the various ISDN-BRI cause values is contained in Table 60: ISDN-BRI
CAUSE VALUES; (BRI-SET/ASAI-ADJ Error Log Notes). This table also contains
recommended actions associated with the cause value. In addition, the Aux Data field of
the Error Log entry contains additional diagnostic information.
p. Error 3847: sets on the port do not support level 3 initialization. Consult the set service
documentation.
Demand test descriptions and error codes
Investigate tests in the order presented. By clearing errors associated with the first test, errors
generated from other tests may also be cleared. Click on the link to see the full description of
the test, error codes, and recommended actions.
Order of Investigation Short Test
Sequence
1. D = Destructive; ND = Nondestructive
Long Test
Sequence
Note:
a. Execute test port long location, and review the results of the BRI Port Local LAN
Looparound Test (#618) to verify the repair.
232 Maintenance Alarms for Communication Manager, Media Gateways and Servers
D/ND 1
Signaling Link Status Test (#626) X X ND
BRI XID Test (#628) X X ND
BRI Layer 3 Query Test (#629) X ( a ) X ( a ) ND
BRI Remote Loopback Test (#627) X ( a ) ND
BRI Set Audits Test (#630) X ( a ) X ( a ) ND