Demand test descriptions and error codes - Avaya Support

POW-SUP (Power Supply)
c. Error Type 257: the Power Supply Recycle Test (#1534) failed. Aux Data shows the
failure(s), according to the table below. Aux Data values may be added together.
Aux Data Description
1 The power supply under test did not restore power.
2 The other power supply did not restore power.
16 The power supply under load failed when the other
power supply was specified in the recycle command.
d. Error Type 513: the +5V is out of tolerance (4.75 to 5.25 V (+/- 5%)).
1. Run test board location.
2. Run status environment.
e. Error Type 769: the -5V is out of tolerance (-4.5 to -5.5 V (+/- 10%).
1. Run test board location.
2. Run status environment.
f. Error Type 1025: the -48V is out of tolerance (-44.2 to -51.8 V (+/- 8%)).
1. Run test board location.
2. Run status environment.
g. Error Type 1281: the +12/14V fan voltage is out of tolerance (+11.4 to +15 V). The nominal
+12V is raised to +14V when there is a hot spot warning or fan failure.
1. Run test board location.
2. Run status environment.
h. Error Type 1537: internal failure.
1. Run test board location.
Aux Data Description
1 Analog-to-digital converter failure
2 Digital-to-analog converter failure
4 Internal Mux failure
8 EEPROM failure
64 Calibration contents CRC check failure
128 Power supply firmware CRC check failure
Issue 5 May 2009 781