Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 472: VC Summer Port Local TDM Looparound Test (#1100) 2 of 2
Error
Code
2000 ABORT Response to the test was not received within the allowed time.
1. If this result occurs repeatedly, reset the circuit pack if the other
ports are idle.
2. Rerun the test.
3. If this result occurs again, replace the circuit pack.
2012
2100
2103
Test
Result
Description / Recommendation
ABORT Internal system error.
Could not allocate the necessary system resources to run this test.
The system could not make the conference connection for the test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The TDM Loopoaround test or the Conference Circuit test failed.
1. Replace circuit pack.
PASS The VC Summer Port Local TDM Loopback test passed.
VC DSP Port NPE Crosstalk Test (#1103)
This test is destructive.
The VC DSP Port NPE Crosstalk Test verifies that this port’s Network Processor Element (NPE)
chel talks on the selected time slot and never crosses over to time slots reserved for other
connections. If the NPE is not working correctly, one-way and noisy connections may be
observed. This test is part of the port’s long test sequence and takes approximately 20 to 30
seconds to complete.
This test runs on VC-DSPPT (Voice Conditioner DSP Port).
1560 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2