Demand test descriptions and error codes - Avaya Support

Table 209: PKT-INT Error Log Entries 2 of 2
Error Type Aux
Data
1025 (h) Any Private
Looparound
(#885)
MAJ ON reset packet-interface location 1
1281 (i) Any MAJ ON reset packet-interface location 1
1537 (j) Any Memory
Checksum
(884)
1793 (k) Any Memory
Checksum
(#884)
MIN ON test packet-interface location l r
2
MIN ON test packet-interface location l r
2
2049 (l) Any WRN ON test packet-interface location r
25
2305 (m) Any test packet-interface location r 2
2561 (n) Any Active-Standby
Peer Link
(#888)
2817 (o) Any Read and Clear
test (#887)
3074
3073
3072 (p)
Associated Test Alarm
Level
Any Maintenance
Looparound
(#886)
MIN OFF test packet-interface location r 2
MIN
MAJ
On/Off
Board
Recommended Action
ON test packet-interface location
WRN OFF test packet-interface location r 2
3585 (q) Any WRN OFF reset packet-interface location 1
3841 (r) Any MAJ OFF reset packet-interface location 1
1. You can reset a Packet Interface module on an active IPSI if it has been taken out of service by the background
maintenance software. A Packet Interface module on a standby IPSI can be reset independent of its service state.
Notes:
a. Error Type 0: an alarm was raised but an associated error was not entered into the error log
due to a momentary overload condition caused by a burst of hardware or software error
reports. Run the long test sequence. Refer to the test description and follow the
recommended procedures.
b. Error Type 1: background maintenance software has reset the Packet Interface module on
an IPSI circuit pack as a fault recovery action. It is used to keep track of the number of times
that the Packet Interface is reset, independent of whether or not the Reset test passed.
When 3 of these errors occur in 15 minutes, maintenance places the Packet Interface into
738 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2