Demand test descriptions and error codes - Avaya Support

4. Enter display alarms and determine the location of the circuit pack with the alarmed
GPTD-PT, DTMR-PT, or GPTD-PT.
Run test board location l r 3 for that circuit pack.
If this does not clear the TTR Level alarm, replace the Tone Detector or Call Classifier
circuit pack with the alarmed GPTD-PT, DTMR-PT, or CLSFY-PT.
Error log entries and recommended actions
Table 272: TTR-LEV Error Log Entries
Error
Type
1 (a) 1
Aux
Data
Associated Test Alarm Level On/Off
Board
2 (b) 2 WRN
(See message below)
3 (c) 3
WARNING: The TTR-LEV Alarm is upgraded to MAJOR if the Base Tone Generator is set to
12 (France).
Notes:
a. Error Type 1: does not indicate a current error condition. It indicates that the number of
DTMR ports in service was below the administered threshold, but is now equal to or greater
than the threshold. These errors are typically generated during boot time or other
transitional states when the ports are being brought into service.
b. Error Type 2: the total number of DTMR ports currently in service is below the administered
threshold. To clear the alarm, see Repair Procedure for TTR-LEV.
c. Error Type 3: does not indicate a current error condition. It indicates that the number of
GPTD ports in service was below the administered threshold, but is now equal to or greater
than the threshold. These errors are typically generated during boot time or other
transitional states when the ports are being brought into service.
OFF
4 (d) 4 WRN OFF
5 (e) 5
6 (f) 6 WRN OFF
7 (g) 7 MAJ OFF
8 (h) 8 MIN OFF
9 (i) 9 MIN OFF
1020 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Recommended
Action