Demand test descriptions and error codes - Avaya Support

Table 403: Expansion Interface Packet Interface Test (#589) 1 of 5
Error
Code
Test
Result
Description / Recommendation
Expansion Interface Packet Interface Test (#589)
1033 ABORT The test cot run because the EI circuit pack does not have a fiber link
administered to it, there is not sufficient data to run the test, or because EI
circuit packs on other port networks needed for this test are out of service.
1. Enter list fiber-link and determine whether the EI circuit pack
under test is an endpoint of one of the administered fiber links. If so,
then proceed to step 2. If not, then this is considered to be a spare
board, and the test should not be attempted on this EI circuit pack.
2. Follow procedures for applicable configuration:
Direct Connect:
1. Enter list config for the cabinet and carrier where the neighbor
EI circuit pack resides. If the results reveal that the board is not
recognized by software, the board is out of service because of this
condition. Perform the following steps:
a. If this test is being executed on an EI circuit pack located in the
PN, enter display errors and resolve any EXP-PN errors for
the port network where the neighbor EI circuit pack resides.
Re-run this test.
b. If this test continues to abort with Error Code 1033, reset the
DS1 converter circuit pack, if so equipped, or the neighbor EI
circuit pack. This will not be destructive since the circuit pack cot
be serving as the Expansion Archangel if it is not in service.
2. Run Test #237 and check for EXP-INTF circuit pack Error Type 1281
in the Error Log. If Error Type 1281 is present and/or Test #237 does
not pass, see repair procedures for Expansion Interface Neighbor
Query Test (#237).
3. If Test #237 passes, reseat the EI circuit pack. This will not be
destructive since the circuit pack cot be serving as the Expansion
Archangel if it is not in service.
4. Rerun Test #237.
1 of 5
Issue 5 May 2009 1377