Demand test descriptions and error codes - Avaya Support

Error log entries and recommended actions
Table 200: OPS-LINE Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test station ext
15 (b) Any Port Audit and Update
Test (#36)
18 (c) 0 busyout station
ext
WRN OFF release station ext
130 (d) WRN ON test station ext
1281 Conference Circuit Test
(#7)
MIN ON test station ext l r 4
1537 NPE Crosstalk Test (#6) MIN ON test station ext l r 3
1793 (e) test board location l
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
b. Error Type 15: software audit error which does not indicate a hardware malfunction. Run
the short test sequence and investigate associated errors (if any).
c. Error Type 18: the DS1 OPS Line was busied out by busyout station ext. No calls
can be made on this line. Release the line with release station ext.
d. Error Type 130: the circuit pack was removed or was insane for more than 11 minutes. To
clear the error, reinsert or replace the circuit pack.
e. Error Type 1793 there is a problem with the DS1 Interface circuit pack. Because there is no
error against the OPS-LINE port, no alarm is raised against the OPS-LINE port. However,
there should be errors logged against the DS1 Interface circuit pack. Look for DS1-BD/
UDS1-BD errors in the Error Log, and follow the procedures in DS1-BD (DS1 Interface
Circuit Pack).
696 Maintenance Alarms for Communication Manager, Media Gateways and Servers