Demand test descriptions and error codes - Avaya Support

Major Alarm Inquiry Test (#142)
Major Alarm Inquiry Test (#142)
The Major Alarm Inquiry Test determines if the received average DS1 bit error rate on the DS1
facility is greater than 1/1000. All trunks on the DS1 board are put in the out-of-service state if a
Major Alarm lasts for more than 20 minutes.
When the Major Alarm is cleared, all trunks on the DS1 board are restored to their previous
service state before the Major Alarm occurred.
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MAPD-BD (MAPD Interface Circuit Pack)
● MG-DS1 (DS1 Interface Media Module)
● UDS1-BD (UDS1 Interface Circuit Pack)
Table 341: Major Alarm Inquiry Test (#142) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time. This may
be due to hyperactivity.
1. Enter display errors
2. Check for Error Type 1538 for this DS1 board. If Error Type 1538
appears in the error log for this board, see Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module for the repair procedures.
Otherwise, retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2
Issue 5 May 2009 1251