Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 410: Link Status Test (#601) 2 of 2
Error
Code
Test
Result
Description / Recommendation
3 FAIL Received no response to RSCL control link test frame.
1. Retry command at 1-minute intervals up to 5 times.
2. If the problem persists, reset the circuit pack with
reset board location.
3. If test continues to fail, replace the circuit pack.
PASS RSCL control link connected.
TSC Heartbeat Inquiry Test (#604)
This test can be invoked for any ADM TSC administered in the switch. Most of the error
conditions in the following table will not log an error, but switched services may take some type
of recovery action in certain instances.
This test sends a USER INFORMATION TSC heartbeat message inquiry across an ADM TSC.
It passes if the far end sends a response. It fails if there is no response.
This test runs on TSC-ADM (Administered Temporary Signaling Connections)
Table 411: TSC Heartbeat Inquiry Test (#604)
Error
Code
Test
Result
Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Enter test tsc-administered at 1-minute intervals up to 5
times.
1005 ABORT The Administered TSC does not exist.
1. Display the administration for the Administered TSC.
2. If an Administered TSC exists, enter test tsc-administered.
1113 ABORT The D-chel is out-of-service.
1. See ISDN-PLK (ISDN-PRI Signaling Link Port).
1392 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2
1 of 4