Demand test descriptions and error codes - Avaya Support

. Run test synchronization r 10 to see if new 2305 errors are reported
against the new active Tone-Clock circuit.
c. If not, replace the standby Tone-Clock circuit. See Replacing the IPSI or
Tone-Clock Circuit Pack.
If this clears the error, the problem has been resolved.
5. Replace the EI circuit pack for the active PNC.
6. If the problem is still not cleared and the IPSI or Tone-Clock circuit pack reported in the
error log has not yet been replaced, replace it. See Replacing the IPSI or Tone-Clock
Circuit Pack.
Demand test descriptions and error codes
Investigate tests in the order presented. By clearing errors associated with the first test, errors
generated from other tests may also be cleared. Click on the link to see the full description of
the test, error codes, and recommended actions.
Order of Investigation Short Test
Sequence
Long Test
Sequence
970 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Reset
Board
Sequence
SAKI Sanity Test (#53) X D
Clock Health Inquiry Test (#46) X X ND
Control Chel Looparound Test (#52) X X ND
Tone Generator Crosstalk Test (#90) X ND
Tone Generator Transmission Test (#40) X X ND
Tone Generator Update/Audit Test (#41) X X ND
TDM Bus Clock Circuit Status Inquiry Test (#148) X X ND
TDM Bus Clock Slip Inquiry Test (#149) X X ND
TDM Bus Clock PPM Inquiry Test (#150) X X ND
TDM Bus Clock Parameter Update Test (#151) X X ND
Board Type Check Test (#574) X X ND
Standby Reference Health Check Test (#651) X ND
1. D = Destructive; ND = Nondestructive
D/ND 1