Demand test descriptions and error codes - Avaya Support

The two maintenance commands for ADM TSCs are:
TSC-ADM (Administered Temporary Signaling Connections)
● test tsc-administered signaling-group-number [/tsc-index]
● status tsc-administered signaling-group-number [/tsc-index]
Error log entries and recommended actions
Table 271: TSC-ADM Error Log Entries
Error
Type
3840 to
3967 (a)
Aux Data Associated Test Alarm
Level
tsc index # test tsc-administered
Note:
a. Error Types 3840 - 3967: there is no test to clear these Error Types.
Any of these errors indicates that a TSC Heartbeat Inquiry test was run on an active
far-end Administered TSC from the switch. Upon receiving the heartbeat message, the
network communicated that the call was unable to complete. As a result, the error was
logged.
1. Check the signaling group status of the D-chel or D-chel pair using status
signaling-group grp# for the Administered TSC.
2. Check the status of the Administered TSC using status tsc-administered.
3. Also check the administration of the Administered TSC on the switch.
This error may only be affecting service for some DCS customers. Upon receipt of this
error condition, the switch will tear down and re-establish the ADM TSC within 20 minutes.
The Port field in the error log contains the signaling group number for TSC-ADM errors.
Demand test descriptions and error codes
Order of Investigation Short Test
Sequence
On/Off
Board
Long Test
Sequence
D/ND
Recommended
Action
TSC Heartbeat Inquiry Test (#604) Nondestructive
Issue 5 May 2009 1017